ELECTRONICS

Electronics, verified
down to the pin.

We develop where software and hardware meet: microcontrollers, FPGA, interfaces and measurement — and we take a close look when a signal does not do what it should.
Close-up of an assembled circuit board

Focus areas.
Hardware that works hand in hand with software.

01 · Assemblies

Electronics development

Electronic assemblies for prototypes and small series — matched to firmware, enclosure and operating conditions.

02 · Controllers

Microcontrollers & FPGA

ARM, PIC, x86 and other microcontrollers, plus programmable logic (FPGA/EPLD) with Verilog.

03 · Interfaces

Bus & interfaces

SPI, USB, CAN, I²C, RS485 and RS232 — robustly connected, cleanly timed, cleanly documented.

04 · Measurement

Commissioning & failure analysis

Know-how and measurement equipment to check signals directly at pins and circuit sections — from first power-up to root-cause analysis.

In practice · Failure analysis

Unreliable RS485 link

An almost finished device sporadically lost data on the RS485 bus. With the oscilloscope we found faulty driver-enable timing triggered by an interrupt routine of the CAN bus.

The solution: leaner interrupt routines, corrected priorities and a ring buffer — the device went into series production without a hardware change.

Circuit board developed by eMBe-soft

Components.
What we work with.

ARCHITECTURES
ARMPICx86other microcontrollersFPGA/EPLD
BUS & INTERFACES
SPIUSBCANI²CRS485RS232

Let's talk about your electronics.

Whether early concept, prototype or ongoing project — write to us. We will get back to you promptly and without obligation.
Fraunhoferring 23 · 85238 Petershausen · Germany
Scroll to Top